Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Cleveland Park?
Garage door work in Cleveland Park typically runs $150 – $600 for most repairs, with the exact figure set by the written estimate. A single spring replacement is usually $180 – $340, an opener repair is $120 – $320, and a brand-new door installation is $700 – $2200. Those are typical estimated ranges for this DC market, not a quote; what you pay depends on the door, the part, and what we find when we look at the system.
We handle the full range here, from a snapped torsion spring to a full replacement, and we work on the major brands you’re likely to have: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Estimates are free, and we’ll tell you straight what the door needs before anyone touches a tool. Call (855) 658-4168. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday.
Garage Door Cost Breakdown (2026)
Here’s what the common jobs actually cost around Cleveland Park this year. Every range below is a typical estimated price; the written estimate you get on site is the number that counts.
| Service | Typical Estimated Cost |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2200 |
One thing worth flagging up front: the spring price above is for a single spring. Most doors run a matched pair, and when one breaks the other has usually lived the same life, so the pair is replaced together and costs about twice that range. We’ll show you both springs and let you decide, but a spring that’s shared the same wear is the kind of part we’d rather swap now than see fail a month later.
What pushes a job toward the top of a range? A heavier or oversized door, a torsion system that needs recalibration, an opener that’s failed in a way that means replacement rather than repair, or a panel that has to be ordered to match an older door. Routine jobs – a roller set, a track that’s slipped out of line – sit near the bottom. The door in front of us decides, and we don’t pad it.
What Affects Garage Door Pricing in Cleveland Park
Cleveland Park isn’t a generic suburb, and the housing here shapes the work. This is an old, established neighborhood of detached houses, brick colonials, and the occasional newer build, and a lot of the garages were added or converted long after the houses went up. That history shows up in the price.
- Door age and system type. Plenty of Cleveland Park garages still run older extension-spring systems or single-piece tilt doors, and those parts aren’t always the same as a modern sectional. A technician who knows both platforms quotes accurately; a generalist guesses and the estimate drifts.
- Wood and carriage-style doors. The neighborhood has a lot of traditional wood and carriage-house style doors that fit the architecture. Those need careful panel work and finishing, which costs more than a plain steel sectional but keeps the front of the house looking right.
- Tight or low-clearance garages. Older DC garages are often shallow, with low headroom or a short driveway. Low-clearance situations change which opener and which spring setup will actually work, and that affects the parts and the labor.
- Brand and parts availability. We’re trained across eight major manufacturers, so we diagnose the system you have rather than steering you toward whatever’s easy to source. A LiftMaster opener, a Genie, or a Chamberlain all get the right part, not a workaround.
- What failed and how far it spread. A snapped cable can throw a door off-track; a failed spring can bend a panel or stress the opener. The more a single failure touched, the more of the door the repair covers.
- Repair versus replace. On an older door with several worn systems, patching one part at a time can cost more over a year than a clean installation. We’ll price both so you can compare honestly.
If your door has stopped working and you’re not sure whether it’s a spring, a cable, or the opener, that diagnosis is the first thing we sort out. The full range of what we handle lives on our garage door repair Tenleytown page if you want the broader picture of our service.
What Does Each Type of Garage Door Job Cost?
Breaking the numbers out by job helps you budget before you call. These are the same typical estimated ranges from the table above, explained in plain terms.
Spring repair: $180 – $340 per spring
Springs carry the weight of the door, and they’re the most dangerous part of the whole system to work on. A torsion spring under tension holds a serious load, and handling one without the right winding bars and training is how people get hurt. We don’t recommend DIY here. Our technicians have up to 13 years of experience with calibrated spring tools, and that’s exactly the kind of job where it matters. A matched pair runs about twice the single-spring range.
Cable repair: $130 – $250
Cables keep the door level and on track. When one frays or snaps, the door can drop or twist, and that’s a genuine safety and security problem. We treat a broken cable as urgent, not a wait-and-see.
Opener repair and installation: $120 – $320 repair, $250 – $550 install
Sometimes the opener just needs a sensor realigned or a gear replaced; sometimes it’s done. We diagnose first. If a LiftMaster, Chamberlain, Genie, or Craftsman unit can be repaired sensibly, we repair it. If it’s failed for good, a new opener install runs $250 – $550 depending on the unit and the door it’s lifting.
Panel, track, and roller work: $110 – $500
Panel replacement is $250 – $500, track realignment is $120 – $240, and a roller set is $110 – $220. These are the everyday jobs that keep a door quiet and square. A door that shudders or scrapes is usually telling you a roller or a track has gone. Catching it early keeps the repair small.
New door installation: $700 – $2200
A full replacement runs $700 – $2200 depending on size, material, insulation, and style. For Cleveland Park’s traditional homes, a wood or carriage-style door that suits the architecture is often worth the higher end. We install across Clopay, Amarr, Wayne Dalton, Raynor, and the other major lines, so the door matches the house rather than the warehouse.
How to Save on Garage Door Work in Cleveland Park
You can’t avoid every repair, but you can keep the bill near the low end of these ranges. A few practical habits do most of the work.
- Fix the small thing first. A noisy door or a slow-starting opener is a cheap fix now and an expensive one later. Rollers and tracks cost far less than a panel or an opener that failed because a worn part dragged on everything else.
- Replace springs in pairs. We know it stings to replace a spring that hasn’t broken yet, but two springs installed at once cost less than two separate visits, and you avoid a second failure weeks after the first.
- Get the diagnosis right the first time. A technician trained on your specific brand won’t misread a Genie opener problem as a door problem or replace a part that wasn’t the cause. Accurate diagnosis is the cheapest thing on the invoice.
- Compare repair against replacement honestly. On a door that’s failed several systems within a short stretch, a new installation at $700 – $2200 can beat a year of piecemeal repairs. We’ll show you both numbers.
- Take the free estimate. It costs nothing to know exactly where you stand. Call (855) 658-4168 and we’ll price it before any work starts.
Repair or Replace: Which Makes Sense in Cleveland Park?
Repair usually wins when one part has failed on an otherwise sound door; replacement wins when several systems are wearing out at once or the door no longer suits the house. A single spring, a cable, or a roller set is straightforward to repair and keeps you well under the general $150 – $600 repair range. A door that’s bent, off-track repeatedly, or running an opener that’s failed on top of worn springs starts to look like a replacement candidate. We price both so the decision is yours, made with real numbers instead of a sales pitch. If you’re leaning toward replacement, our installation service covers the full range of styles and brands, and we’ll help you match the door to Cleveland Park’s architecture.
Why Cleveland Park Homeowners Call Us
We’re a single-trade garage door specialist, not a general home-services company that adds doors to a long list. Every technician we connect you with is a garage door specialist. We work across eight major manufacturers – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor – so the recommendation follows what your door needs, not what’s in stock. Springs, openers, panels, tracks: we diagnose the specific system in front of us. And because a broken door is a security and safety problem, emergency service is a real part of what we offer, not a marketing line. If your door fails and can’t wait, we book it into the next opening. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
FAQs – Garage Door Cost in Cleveland Park
How much does garage door repair cost in Cleveland Park?
Most garage door repairs in Cleveland Park cost $150 – $600, depending on the part and the door. A spring is $180 – $340, a cable is $130 – $250, and opener repair is $120 – $320. Call (855) 658-4168 for an exact quote; estimates are free.
How much does a new garage door cost in Cleveland Park?
A new garage door installation in Cleveland Park typically costs $700 – $2200, based on size, material, insulation, and style. A wood or carriage-style door that suits the neighborhood’s traditional homes sits toward the higher end. Call (855) 658-4168 for a free written estimate.
Is it cheaper to repair or replace a garage door?
A single-part repair is almost always cheaper than replacement, and most repairs land within $150 – $600. Replacement at $700 – $2200 makes more sense when several systems have worn out together or the door is repeatedly going off-track. We’ll price both so you can compare. Call (855) 658-4168 to sort out which applies to your door.
Can you come the same day for a broken garage door?
Yes, same-day service is part of what we offer, and emergencies like broken springs, a door off-track, or a failed opener get priority. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Call (855) 658-4168 and we’ll get you booked into the next opening.
How much does spring repair cost, and is it a pair or a single spring?
Spring repair is $180 – $340 for one spring; a matched pair, which is usually replaced together, costs about twice that. We replace springs with calibrated tools because a torsion spring under load is the most dangerous part of the door to handle. Call (855) 658-4168 for a free estimate on yours.
Get a Straight Price on Your Garage Door
Whether it’s a snapped spring, a stubborn opener, a panel that’s seen better days, or a full replacement, the price on this page tells you where you stand before you call. The written estimate is what sets the final number, and it costs you nothing to get one. Give us a call at (855) 658-4168. We answer 24/7, and fast dispatch runs 7am to 7pm, Sunday through Friday. Tell us what the door is doing and we’ll tell you what it needs.
Pricing reflects the Cleveland Park market as of 2026. Garage Door Repair Tenleytown offers free estimates – call (855) 658-4168.
Written by the team at Garage Door Repair Tenleytown.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Brianna Coleman"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Erin Quinn"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Jennifer Kowalski